EVS Multicam LSM User Manual download pdf (Page 120)

Default Transition Duration with Split Audio

• The simplest type of split audio edit that can be performed on an LSM is to make the

video and audio transitions at the beginning of the clip have different durations, such

as a 12 Frame Video Mix with a 2 sec Audio cross fade.

• The value of the Audio effect duration parameter of the Operational Setup menu (p.3.1

F3) is only taken into account when the Advanced Audio Editing mode is enabled.

Otherwise, the audio effect duration is always locked to the video effect duration,

whatever the value of these parameters.

• If the Audio effect duration parameter in the setup is set to Lock to video, it will never

be possible to adjust independently the duration of the audio and video transitions. If

you want to adjust one of these transitions and the other one follows, please check the

Audio effect duration parameter in the setup, and make sure it is NOT set to Lock to

Video.

How to Activate the Split Audio Mode

To activate the split audio mode, proceed as follows:

1. Enter the Setup menu as described in the Multicam Configuration manual.

2. Enable the Advanced audio editing parameter in the Operational Setup menu (p.3.2

F2).

Split Audio Menu

In Playlist Edit mode, when the Split Audio is activated, the Remote Panel displays V

Base (SHIFT+A) and A Base (SHIFT+B) commands:

V Base A Base Effect Edit all

Insert Speed Fx Dur Delete

Activating the V Base option gives access to the following additional menu. The A Base

menu is similar, but allows corresponding actions on video transitions:

V Base A Base Swap Edit All

A Advance A Delay A Fx Dur A Split

The following table describes the split audio commands in V Base edit. The A Base

commands are the same but relate to the video transitions.

Command Description

A Advance Advances the beginning of the audio transition.

A Delay Delays the beginning of the audio transition.

A Fx Dur Extends the duration of the audio transition on both sides. This creates

an audio delay or advance depending on the modification applied to the

effect duration.

A Split Performs an audio advance or delay by specifying the TC for the

beginning of the transition.

110 5. Playlist Management

EVS Broadcast Equipment S.A. Issue 11.02.A July 2013

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 220 221

No comments

EVS Multicam LSM User Manual Page 120