EVS Multicam LSM User Manual download pdf (Page 66)

To recall a clip on another server than the one you are connected to, proceed as follows:

1. Enter the 3 or 4 digits of the ID, followed by a slash mark (/) and the network number of

the machine (for example 111/03 or 111A/03).

◦ To recall a local clip, whatever machine you are connected to, type 00 as network

number (for example 111/00 or 111A/00).

2. The entry appears in the Name field.

3. Press F3.

◦ If you entered only 3 digits, the clip primary camera is selected.

◦ If you entered 4 digits, the clip given camera angle is selected.

◦ If no clip matches the entry, no selection is done.

4. Press ALT+P to play back the selected clip.

How to Load a Record Train in the VDRPanel

1. Press ALT+L to go in LIVE mode (or click on the LIVE function).

2. Press ALT+the letter of the desired record train (A/B/C/D/E/F), or click on it.

3. The letters corresponding to the available record trains are highlighted in green, and

the letter of the current record train in red.

How to Load a Clip in the VDRPanel

1. Use the arrow keys to move the cursor inside the lower section of the VDR Panel to

the desired clip.

2. Press ENTER, or click on the desired clip with the stylus, or type the desired clip ID

and press F3.

3. To select a different camera angle inside a clip, press ALT+the letter of the desired

camera (A/B/C/D/E/F), or click on it.

4. Available camera angles are highlighted in green, the current camera angle in red.

With a Tablet and a Stylus

To select a different page or bank using the stylus, click on the desired page/bank number

on the bottom line of the screen. You can also move to the adjacent page/bank by clicking

on the red arrows on the top, bottom and sides of the screen:

• Left/Right Arrow: go to previous/next page

• Up/Down Arrow: go to previous/next bank

If a clip is present in a certain location, it will be highlighted in blue. Once selected, it will

be highlighted in orange.

To cue up a clip on the primary channel controlled by the first remote, or on the VGA Call

Channel defined in the setup, simply click on it with the stylus (that is press lightly the tip

of the stylus onto the tablet). If the channel where the clip is supposed to be loaded is in

Plst Edit mode with a PRV channel attached, the clip will automatically cue up on the

PRV channel.

56 4. Clip Management

EVS Broadcast Equipment S.A. Issue 11.02.A July 2013

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 220 221

No comments

EVS Multicam LSM User Manual Page 66