EVS Multicam LSM User Manual download pdf (Page 34)

Mix / Wipe L>R / Wipe R>L / Wipe U>D / Wipe D>U / Cut

Aud.Met. PgmSpd Sort->TC PostRoll

Mix. Sw to IN Search Pref

These options determine the transition effect that will occur between the PGM and PRV

pictures. The mix, wipe and cut are on the same location. Pressing this button will browse

through these effects, showing the active one on the LCD menu. Please refer to Setup

menu to select the duration of the transition effect.

PgmSpd / VarMax

Aud.Met. PgmSpd Sort->TC PostRoll

Mix. Sw to IN Search Pref

Pressing PgmSpd once enables the Program Speed mode and highlights this function on

the LCD. Pressing the key once more enables the VarMax mode and highlights this

function on the LCD. The PLAY key is flashing red while either of these modes is

enabled.

• Program Speed mode: In this mode, only two speed values are available from the

lever: 0% when the lever is in the lower position, or the speed defined in the

Operational Setup menu (p.9.1 F3) for any other position of the lever.

• VarMax mode: the speed range defined by the lever is limited between 0% and the

speed value defined in the Operational Setup menu (p.9.1 F3).

Sw To In

Aud.Met. PgmSpd Sort->TC PostRoll

Mix. Sw to IN Search Pref

When this function is enabled (highlighted), a camera change will cause a jump to the

corresponding IN point if existing. It will switch in Sync if no IN point exists for the current

element, or if SwtoIN is 'OFF'.

See section "Synchronization Mode (Switch To In)" on page 31 for more information on

this option.

Pref

Aud.Met. PgmSpd Sort->TC PostRoll

Mix. Sw to IN Search Pref

Selecting this function enables the Preference mode.

See section "Preference Mode (PREF)" on page 31 for more inforamtion on this option.

24 3. Control Modes

EVS Broadcast Equipment S.A. Issue 11.02.A July 2013

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 220 221

No comments

EVS Multicam LSM User Manual Page 34