EVS Multicam LSM User Manual download pdf (Page 215)

Key Behavior

• TAKE: this key is operational in ARM mode.

• RECORD: the remote beeps if the CAM key refers to an empty block.

• RECORD: pressing this key while the current block is recording does not send any

command to the camera.

• CLEAR: press this key to delete the current memory block data.

Cue points management

• When a new ARM/REC command is issued on a block, all its cue points are cleared.

• If the Last Cue command cannot access the desired TC-pre-roll, the player remains

on the current cue point.

• If the Last Cue command refers to a TC that does not exist anymore, the player

jumps to the beginning of the current memory block.

• Cue points can be marked across several blocks but the recall is limited to the

currently selected block.

Example:

◦ While recording on memory block 1, mark cue points 1, 2, and 3 on memory block

◦ Press TAKE to start recording on block 2 and mark cue points 1, 2, and 3.

◦ Press TAKE and select memory block 2. The Last Cue command scrolls through

the cue points of block 2.

◦ To go through cue points of another block, select that block first then press Last

Cue.

• On OSD, the first information, displayed in white, refers to the cue points on the

playing block while the second information, displayed in red, refers to the recording

block.

Photron Camera

Application Start

At application start, this camera is in ARM mode and the recording starts on the first

memory block.

Configuration Parameter Values

• Port = RS422

• Protocol = Sony 9-PIN

• The PGMSpeed parameter value 1000 is available.

OPERATION MANUAL Multicam LSM 11.02

9. Advanced Control Modes 205

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 221

No comments

EVS Multicam LSM User Manual Page 215