EVS Multicam LSM User Manual download pdf (Page 39)

How to Assign a Camera to a Channel

In Multi PGM mode, to change the current camera on each PGM, proceed as follows:

1. In the primary menu, select the PGM to which you want to change the current camera.

The TAKE key at the bottom of the remote is then lighting red.

2. Press the TAKE key. It lights green and the menu on the LCD display changes to let

you select the desired camera.

Rst Cam Local

CAM A CAM B CAMC CAM D

3. Press the camera you want to associate to the selected PGM.

4. Press TAKE again to return to the PGM selection menu.

Playlist Conditional Mode

This mode is only available in 2PGM and 3PGM modes. It allows the operator to load and

control several playlists simultaneously from the same Remote Panel, or to load a playlist

on one channel while performing other operations on the other channel(s). To use this

mode, the Load Playlist parameter of the Operational Setup menu must be set to

Conditional (p.3.3 F2).

To use this mode, select one channel (for example PGM1), and press the PLST key one,

two or three times to enter the PLST EDIT or the PLST DIFF mode (refer to the “Playlist

Management” Section of this manual for details about these modes). You can notice that

the TAKE key lights green. Pressing the TAKE key will allow the operator to return to the

PGM selection menu, and select another PGM channel where he can start a replay, load a

clip or another playlist, etc.

In this mode, if the operator selects a PGM channel where a playlist is loaded and presses

the TAKE key, he will enter again the PLST EDIT or PLST DIFF mode.

When playlists are loaded on all channels currently controlled by the operator in Multi

PGM mode, the TAKE key lights red. If the TAKE key is pressed, the remote will enter a

specific PLST DIFF mode, where the operator can control several playlists

simultaneously, and browse them or roll them in sync. NEXT and SKIP functions are also

available and will apply on all controlled playlists. The TAKE button will not light red if one

of the controlled channels does not contain a playlist.

OPERATION MANUAL Multicam LSM 11.02

3. Control Modes 29

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 220 221

No comments

EVS Multicam LSM User Manual Page 39