EVS Multicam LSM User Manual download pdf (Page 219)

How to Configure the Video Delay Parameters of a Play

Channel

To configure the Video Delay Parameters of a Play Channel, proceed as follows:

1. Select the play channel to configure by pressing ALT+the corresponding F_ key on

the PC keyboard (ex: ALT+F1 for PGM1, ALT+F2 for PGM2/PRV, etc)

2. If you want to use another server on the SDTI network as a source, press SHIFT+F7

on the PC keyboard to call up the network list. Use the arrow keys to select a server,

and press ENTER to validate.

3. Select the camera angle: use the left / right arrow keys, or the TAB key to move the

green cursor on the desired camera, then press ENTER. The new camera angle is

loaded on the channel.

4. Set the new value for the delay: use the left / right arrow keys, or the TAB key to move

the green cursor over the TARGET DELAY field, and enter the desired delay value in

hh:mm:ss:fr. Press CTRL+the corresponding F_ key on the PC keyboard to

activate the new delay on the selected channel (ex: CTRL+F1 start the new delay on

PGM1). If the duration of the record train is lower than the target delay, the channel will

pause on the first recorded picture until the record train is long enough for the desired

delay. In this case, the message “WAIT” is displayed on the OSD of that channel.

9.7. Sony, XtenDD35, Odetics & VDCP

Protocols

These protocols allow the server to be controlled by external devices.

Sony BVW75 Protocol

This protocol allows the server to be seen as a VTR by the controlling device. On a

playback channel, all usual transport commands (play, PlayVar, pause, goto timecode,

pause, stop, etc…) are supported. On a record channel, only Rec and Stop commands are

supported.

This protocol is the simplest one but does not support clip management. It should be used

when the controlling device does not support the XtenDD35, Odetics or Louth VDCP

protocols (ex: edit controllers, NLE applications, some video switchers, VTR controllers,

etc.)

XtenDD35 Protocol

This protocol is based on the Sony BVW75 protocol for all standard transport commands.

It has extended commands so that it supports clip management: using this protocol, the

controlling device can create, name, recall and delete clips.

This protocol can be used with Thomson/GVG XtenDD range of switchers, and with DNF

ST300-EVS and 4040CL-EVS controllers.

OPERATION MANUAL Multicam LSM 11.02

9. Advanced Control Modes 209

1 2 ... 214 215 216 217 218 219 220 221

No comments

EVS Multicam LSM User Manual Page 219