EVS Multicam LSM User Manual download pdf (Page 33)

Local

Rst Cam Local Sync Prv 2nd CTRL

Cam A Cam B Cam C Cam D

This function allows the user to reconnect to the local LSM after having accessed distant

clips or record trains. The function is highlighted when the user is connected to both clips

and record trains on the local LSM. It is displayed only on Master/Server LSMs when they

are connected to the SDTI network.

Sync Prv

Rst Cam Local Sync Prv 2nd CTRL

Cam A Cam B Cam C Cam D

This option allows the user to synchronize the PRV with the timecode and speed of the

PGM output. This function is not available with remote record trains.

2nd CTRL

Rst Cam Local Sync Prv 2nd CTRL

Cam A Cam B Cam C Cam D

This function allows the operator to swap the control of one or several play channels

between the EVS Remote and a third-party controller. Both controllers receive

permanently the status of the channel(s), but only one controller at a time is able to

actually control a channel. The secondary controllers are defined in page T2.2 of the

Technical Setup menu.

Press this function to enter the 2ndCTRL menu, select the channels that you want to

pass to the secondary controller by pressing the corresponding A or B key, then press D

(DONE) to validate your selection. Do the same to bring the control of a channel back to

the EVS remote.

See section "Secondary Controller" on page 32.

3.2.3. 1PGM+PRV Secondary Menu Controls

Introduction

The secondary menu in 1PGM+PRV mode, illustrated below, gives access to the

functions detailed in the following paragraphs:

Aud.Met. PgmSpd Sort->TC PostRoll

Mix. Sw to IN Search Pref

OPERATION MANUAL Multicam LSM 11.02

3. Control Modes 23

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 220 221

No comments

EVS Multicam LSM User Manual Page 33