EVS Multicam LSM User Manual download pdf (Page 23)

Warning

In order to guarantee the validity of data and clips previously saved, it is advised

to properly exit the application by pressing ALT+Q and ENTER from the

keyboard, or F6 and then ENTER from the Remote Panel. Do not turn off the

system while the application is running.

2.3.2. Function of the Small Keys

This function allows the operator to gain access to the secondary menu.

SHIFT+MENU on the Remote gains access to the main menu.

Also used as an ESCAPE key to cancel some options and messages.

CLEAR

This function clears the IN / OUT/ playlist / CLIPS / CUE points.

Note

• To clear one CUE point, recall the desired cue point and press

CLEAR+MARK key.

• To clear all cues: when current picture is not a CUE point, press

CLEAR+MARK key. A message appears to confirm the command.

ENTER

This function appends clip(s) at the end of the current playlist. This is also used to confirm

saving of clips, and validate various options and messages.

2.3.3. Function of the Operational Block 1 Keys

Loop

It enables the internal Loop mode. The button will flash red in this mode and “LOOP” will

appear on the OSD of the output monitors. When the user selects the Loop mode, the loop

has to be cabled from the HD/SD “clean” output of PGM1 to the Loop In connector.

The loop is performed on the audio and video components of the PGM1 output, or on the

video only, depending on the Internal Loop parameter of the Operational Setup menu,

(p.9.2 F6). In audio embedded, the audio is also looped, whatever the value defined for the

Internal Loop parameter.

To leave the loop mode, you need to press SHIFT+LOOP again.

OPERATION MANUAL Multicam LSM 11.02

2. Working Interfaces 13

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 220 221

No comments

EVS Multicam LSM User Manual Page 23