EVS Multicam LSM User Manual download pdf (Page 62)

4. Press SHIFT+Page+F_ key to select the page where the clip will be stored (page 1

contains clips 110 to 199, page 2 contains clip 210 to 299, and so on).

5. Press SHIFT+F_ key to select the bank where the clip will be stored (use F1 to F9

keys as F10 is reserved for the playlist bank available on each page).

6. Press F_ key to select the location of the clip.

The clip is created in the specified location. The primary timecode of the clip is the primary

timecode defined on the train where and when the clip has been created.

Note

Press the F0 key on the Remote Panel to save ALL clips and playlists.

Example

To create a clip in location 213 (page 2, bank 1, location 3):

1. Press SHIFT+Page+F2 to select page 2.

2. Press SHIFT+F1 to select bank 1.

3. Press F3 to select location 3 on the selected page.

In the VGAInterface

To create a new clip in a player window of the VDR Panel, proceed as follows:

1. Load a record train on the player.

2. Browse the record train to reach the desired Short IN or Short OUT point.

In a Player or in a Recorder window of the VDR Panel:

3. Press ALT+I or ALT+O to mark the Short IN or Short OUT point on the current

picture.

4. The cursor is automatically placed in the adjacent field, so you can manually enter, if

you know it, the timecode of the desired Short IN or Short OUT point . Press ENTER

to confirm or ESC to cancel.

5. You can repeat this operation to define the complementary Short IN or Short OUT

point.

6. Press ALT+A-F to select and deselect the record train(s) from which the clip(s) will be

created. The letters highlighted in RED mean that a clip will be created from the

corresponding record train and the letters highlighted in GREEN mean that the

corresponding record train is available but will not be used to create a clip.

7. You can specify the name of the clip before saving it. Press ALT+N then enter the

desired name and confirm it with ENTER.

8. In a Recorder window, you can restripe the timecode of the IN point to a new value.

Press ALT+T, enter the desired value and confirm with ENTER. When creating the

clip, this timecode will replace the original one of the Short IN point.

52 4. Clip Management

EVS Broadcast Equipment S.A. Issue 11.02.A July 2013

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 220 221

No comments

EVS Multicam LSM User Manual Page 62